The Polymaker PA6-CF guide has been updated.

@namek2077 With the 3d printed hammer im using its working great. With the new trip bar it should be flawless has plenty of carrier energy so it runs real nice

@namek2077 Trip bar was slipping under the carrier after a few rounds so I didn’t run full mag, already fixed the issue so I gotta go back to the range tomorrow for full mag dump.

@JLSchjodt 90 degree here shoulda been using the 80

@ThePeac0ck Polymaker PLA Pro

@IiTheboi The method im using can easily be adapted to other platforms so anything is possible

@Ademan555 Was PLA pro I did it pretty dirty on the last mag and put the RCM 90 degree LP in with 124 grain nato and a suppressor on ROF was super high.

@AtrizineWarrior Yep

@tscarrithers This is the unreleased ARMP5 V3 lower, the Leber v2 will auto support this at some point as well

RT @xhoop: Want to use AR15 triggers in your mp5? Check out the Leber v2. cc @theestallion @s3igu2

@FireBirdPrints @pembie000ind Most likely it would work.

@YoungMOOBY And yes the AK-DIAS pushes down on the disconnector basically just think of it like a normal AR15 DIAS they function very similar.

Really weird looking hammer

@row_68888

@jayq29163015 Leber V2 its in beta rn

@TheWadeHammond Omega 9K