When it’s was a bit damp for harvesting we kept our selves distracted with this little project… Bit of fun and hope it brings a few smiles…

@GlenoraAg I know exactly how much they cost… and when I went there to get one they said you should not be breaking that…. But we do have 6 in stock…!! We break at least one a year, we are better at welding them up now once we got the bill…

Anyone had any similar issues and or have any solutions. Be happy to hear any recommendations. Thanks in advance

RT @tom_mahoney15: Gday all, bit of a Hail Mary but wondering if anyone knows of a 5333 or 5365 sprayer parked up somewhere that would have…

@Tomcurnow10 @rileycurnow Good stuff mate, how did the pipe unrolling machine work?

@Tomcurnow10 @CodyJHar Yeah we dealing with 100m rolls too, lots of joining. Good luck

@Tomcurnow10 @CodyJHar Awesome, looks good. Guessing the circular platform is up high so the larger ring will clear the frame/hook up point..? Look forward to seeing the final product…, I better get my welder out I think…

@ajwood091184 Our machine mate

For sale 1380 Convio Flex front. Left hand frame damage in season 22. Front repaired and new mats for season 23. Used only for 180ha of direct heading beans in 23 season and ran without fault. Still a great front with lots of life left in it. Approx 620 hours total use. $110k inc

@Wamballup Pipes about 600-650mm deep. 18 meters apart with no sock or rock/aggregate. First try, will see how it pans out over the next few years

@R_BAgriculture We have an open outflow tench we dug with excavator that runs to a salt lake. We are lucky to have that close by as a place for a water to run to.

@phil_honey @gsandral Yea have been following a bit of your work, looks very interesting. We have put about 11km of pipe in on this project so far in runs of about 500 meters each pipe. Keep up the good work, will have to get in touch for a discussion sometime soon.

@CodyJHar Target depth on install was about 600mm. We have had approx 220mm since it was laid, had had about 115mm before we seen any water start to flow out of pipes.

@LiddellClaying At 18 meters at this stage. From research this may not be close enough in heavy clay soils. Prepared I may have to go closer in future. Still very much learning as we go

@niels_corfield No not specifically. Large open outflow trench on lower side of paddock approx 2m deep that pipes drain to does allow a bit of surface water to drain into in spots.

@Nick67126028 Happy to have a chat and discuss if you would like to send me a private massage and go from there

@ScottYoung6311 Pretty much full grid, 18meter spacing running parallel to open outflow trench across paddock. Taking into account very flat paddock with main elevation change in billabongs. Elevations maps were taking into account on drainage plan